Application
A high flow rate valve for controlling water flow into large tanks. Designed to reduce pump run time.
Video
 |
Dual level Reservoir Valve. |
| Run-time: 38 seconds |
 |
|
Standards
- New Zealand Pat. 239796
- Australian Des. Reg. 110781
- Australian Pat. No. 653422
Specifications
| Working pressure |
0 - 700 kPa [0 - 100psi] |
- Minimum temperature: 1˚C.
- Valve is fully adjustable to allow water level to fall between 65 and 270 mm before opening.
- Reduces pump motor overload.
- DR (Dezincification Resistant) lever.
Flow Chart
Installation
- Inlet pipe must be horizontal and firmly mounted.
- Inlet flow may need to be reduced at inlet pressure above 500 kPa [72psi].
- Under certain conditions it may be advisable to install a Water Hammer Arrestor.
- Fixed Arm must NOT be bent.
Water level differential between pump turning on and off:
A = 200mm gives 65mm water level drop.
A = 375mm gives 270mm water level drop
NOTE¹: Arm distance Min = 200mm & Max = 375mm
NOTE²: Tank Extenders and Extra Back Nuts are available to provide required 150mm spacing
between tank wall and valve body (See Product Codes above). |
|
 |
|
|
Product Codes
| RES DL 32 |
32mm (1¼" BSP) |
| RES DL 40 |
40mm (1½" BSP) |
| RES DL 50 |
50mm (2" BSP) |
| Tank Extenders |
| RXTTI 32 |
32mm |
| RXTTI 40 |
40mm |
| RXTTI 50 |
50mm |
| Extra Back Nut |
| RXBN 32 |
32mm |
| RXBN 40 |
40mm |
| RXBN 50 |
50mm |
|
