Application
High pressure systems to protect drink dispensers e.g. Water filters, ice makers, coffee machines and reverse osmosis machines.
Standards
- NZ Building Code G12 (2001)
- NZS 4608:1992
- Watermark Approval AS 1357.2 Lic. 02596
Specifications
| FM |
Inlet: |
15mm, 1/2" BSP (female) |
| Outlet: |
8mm 1/4" BSP (female) |
| Length |
94mm |
| FMP |
Inlet |
1/4" John Guest connector |
| Outlet |
1/4" John Guest connector |
| Length |
98mm |
| FMBP |
Inlet |
15mm, 1/2" BSP (female) |
| Outlet |
1/4" John Guest connector |
| Length |
98mm |
| Flow rate: |
15 L/min at 700 kPa [100 P.S.I.] inlet pressure |
| Pressure ratio: |
10:1 (for every 10 kPa [1.5 P.S.I.] increase in inlet pressure above 1000 kPa
[150 P.S.I.], the
outlet pressure will increase by 1 kPa [0.145 P.S.I.]). |
| Outlet pressures: |
350 and 600 kPa [50 and 80 P.S.I.] |
| Maximum inlet pressure: |
1600 kPa [230 P.S.I.] |
| Maximum temperature: |
FM 60°C
FMP and FMBP 40°C |
| Minimum temperature: |
1°C |
- Integral Dual Check Valves (Australia Only).
- Resists water hammer.
- Stops backflow.
- FM fitted with integral line strainer.
- FMP supplied with fixing clip and screw.
- FM DR (Dezincification Resistant) brass.
- FMP Acetyl plastic.
- FMBP DR brass inlet, acetyl plastic outlet
Installation
- Installation must be carried out by a Qualified Person.
- All pipe work must be flushed prior to installation.
- Must be protected by a line strainer (integral with FM).
- Do NOT apply heat near valve during installation.
- May be fitted in any orientation.
- Must be fitted downstream of approved isolating valves.
|
 |
|
|
Product Codes
| FM350 |
350 kPa |
| FM600 |
600 kPa |
| FMP350 |
350 kPa |
| FMP600 |
600 kPa |
| FMBP350 |
350 kPa |
US & Canadian Spec Only Product Codes
| FM60 |
60 P.S.I. |
| FMP50 |
50 P.S.I. |
| FMP60 |
60 P.S.I. |
| FMP85 |
85 P.S.I. |
|
