Application
- Low and high (mains) pressure systems.
- Any application where filter, non-return or isolating valve is required.
Features and Benefits
- Compact 3-in-1 valve (filter, isolating and non-return) with high flow rates.
- No tools required to service the valve
- All servicing can be done with water supply on.
- N.Z. forged, high quality, corrosion resistant DR brass body.
- Machined, assembled and 100% tested in N.Z.
Video
 |
Filter Stop Valve. |
| Run-time: 31 seconds |
 |
|
Standards
- Complies with NZ Building Code G12 (2001)
- Complies with NZS 4608:1992
- NZ Patent No. 230940
- Aust Patent No. 625338
Specifications
| FS15 |
Inlet |
15mm, 1/2" BSP (male) |
| Outlet |
15mm, 1/2" BSP (female) |
| Length |
86mm |
| FS20 |
Inlet |
20mm, 3/4" BSP (male) |
| Outlet |
20mm, 3/4" BSP (male) |
| Length |
88mm |
- 60 mesh (250 micron), stainless steel filter
- Non-return check valve cartridge
- Maximum inlet pressure:
- Plastic Cap: 1000 kPa [150psi] @ 40˚C
- Brass Cap: 1600 kPa [232psi] @ 65˚C
- Minimum temperature: 1˚C.
- DR (Dezincification Resistant) brass.
Flow Chart
Installation
- Refer to Technical Area
for installation guide.
- Can be installed in any orientation but is best with filter bowl down for ease of
cleaning.
- Do NOT install in the ground.
- Do NOT apply heat near the valve during installation.
Servicing
The filter may be cleaned without the need to isolate water supply, no tools required.
- Turn handle clockwise to close valve,
- Remove filter bowl,
- Remove and clean filter,
- Refit filter, filter bowl and turn on fully.
Sectional View
|
|
 |
|
|
Product Codes
| FS15 |
15mm |
| FS20 |
20mm |
| FSBC15 |
15mm Brass Cap - Hot Water |
| FSBC20 |
20mm Brass Cap - Hot Water |
|
